no is patched my friend well, i think the same maybe is NAND CORruption .. well i try with briccmiiv2It can be NAND corruption... Is you console patched?
Try to check NAND with "briccmiiv2" i saved few consoles with this tool.
Also when FW doesn't match burned fuses it will behave similar.
no is patched my friend well, i think the same maybe is NAND CORruption .. well i try with briccmiiv2
i tested usb in board all pins with continuity and they are fine.Usually when console go past this logo it should go in fast charge mode, may be fast charging portion of the chip shorts rail and console just can't past this stage.
Check with USB tester what it draws from the charger when it happens.
Also i would check voltages when it starts on 5th and 6th pin of the M92T36.
i tested usb in board all pins with continuity and they are fine.
i will try software for now
ok, i dont know software NSwitch, all is new for me and my inglish is bad xdTry briccmiiv2 very simple and easy tool.
ok, i dont know software NSwitch, all is new for me and my inglish is bad xd
well tomorrow keep on work
says everthing is fineOh... usually it says if it corrupted or not...