Hardware Nintendo switch dont start after nintendo logo

[andres1234]

hi, i have this nintendo i replace m92t36 and shorts is gone, but problem still



have any idea

 

[Agilato]

It can be NAND corruption... Is you console patched?
Try to check NAND with "briccmiiv2" i saved few consoles with this tool.
Also when FW doesn't match burned fuses it will behave similar.

 

[andres1234]

It can be NAND corruption... Is you console patched?
Try to check NAND with "briccmiiv2" i saved few consoles with this tool.
Also when FW doesn't match burned fuses it will behave similar.

no is patched my friend well, i think the same maybe is NAND CORruption .. well i try with briccmiiv2

 

[Agilato]

no is patched my friend well, i think the same maybe is NAND CORruption .. well i try with briccmiiv2

Usually when console go past this logo it should go in fast charge mode, may be fast charging portion of the chip shorts rail and console just can't past this stage.
Check with USB tester what it draws from the charger when it happens.
Also i would check voltages when it starts on 5th and 6th pin of the M92T36.

 

[andres1234]

Usually when console go past this logo it should go in fast charge mode, may be fast charging portion of the chip shorts rail and console just can't past this stage.
Check with USB tester what it draws from the charger when it happens.
Also i would check voltages when it starts on 5th and 6th pin of the M92T36.

i tested usb in board all pins with continuity and they are fine.
i will try software for now

 

[Agilato]

i tested usb in board all pins with continuity and they are fine.
i will try software for now

Lol... i just realized that your console is not on the charger =) stupid answer from me....

 

[andres1234]

i try obtain biskeys but i cant obtained
>8{

with lockpick i cant too

--------------------- MERGED ---------------------------

 

[Agilato]

Try briccmiiv2 very simple and easy tool.

 

[andres1234]

Try briccmiiv2 very simple and easy tool.

ok, i dont know software NSwitch, all is new for me and my inglish is bad xd
well tomorrow keep on work

 

[Agilato]

ok, i dont know software NSwitch, all is new for me and my inglish is bad xd
well tomorrow keep on work

Loads same way as other payloads, you will find it here https://switchtools.sshnuke.net/
Very easy "2 buttons tool"

 

[andres1234]

is fine? i try briccmiiv2
says 9 fuses burn

 

[Agilato]

Oh... usually it says if it corrupted or not...

 

[andres1234]

Oh... usually it says if it corrupted or not...

says everthing is fine
btc entry all correct


i used this https://sdsetup.com/biskeygen i upload
Hekate fuse_cached.bin
Hekate tsec_keys.bin
and i have derive bis keys
this is correct? and what i have to do now? i have biskeys in a worpad