Hardware NEW 3DSLL HARDMOD DOWNGRADE SHOWS CODE LIKE THIS

[RUILIN]

00F800EF
FFFFFFFF FFFFFFFF
00000022 00000000
My computer can not read the nand chip.
Did I connect the threads wrong or my card reader can not support the hardmod?
I remeber my card reader read o3dsll chip successfully.

 

[Dennis G]

get a anker 3.0 usb reader, that one is 100% compatible, i had lot of issues with different readers get that one if that one does not work something is wrong with your wiring. first get an anker then judge.
i also have a youtube video on how to read/write hard mod, link:

 

[milerwan]

Get any USB2.0 or USB3.0 SD reader compatible with MMC II memory.
Anker model is not the best choice for me.

 

[evandixon]

In my experience, using a Transcend USB 3.0 reader, it's important not to wait more than a second or two after turning on the console before plugging the SD reader into the computer. Waiting too long makes the computer unable to properly read it.

 

[milerwan]

In my experience, using a Transcend USB 3.0 reader, it's important not to wait more than a second or two after turning on the console before plugging the SD reader into the computer. Waiting too long makes the computer unable to properly read it.

1. Before switch on the console, the SD reader must be plugged to the cable (and not inserted to the USB port of the computer).
2. When switch on the console, blue screen appears (don't pay attention to the error code, it varies depending on the cable length/resistance of the SD reader).
3. Then plug the "SD reader + cable + console switch on" to the USB port and wait some seconds and the detection window will appear.
-> No timing need to plug the SD card reader to the computer, you could wait 1 day and plug it, it will still be detected.

 

[Dennis G]

1. Before switch on the console, the SD reader must be plugged to the cable (and not inserted to the USB port of the computer).
2. When switch on the console, blue screen appears (don't pay attention to the error code, it varies depending on the cable length/resistance of the SD reader).
3. Then plug the "SD reader + cable + console switch on" to the USB port and wait some seconds and the detection window will appear.
-> No timing need to plug the SD card reader to the computer, you could wait 1 day and plug it, it will still be detected.

yeah pretty much what i explain + show in the video

 

[milerwan]

I haven't see your video and yes it's the same way. '
It is just to reply to UniqueGeek wrong information about short delay to plug SD reader to computer.