Hacking My switch not boot - black screen

[luxe001]

My switch, after update to 10.2 (hekate 5.3.3 + Atmosphere) show a black screen and not boot to hetake Home (i'm using autorcm). BUT IF a put usb-C using and TEGRA on PC, hekate logo appear after 2 seconds and go to home 5.3.3. I enable emuMMC too ....but ...nothing. Before update 10.2 boot without problems. IF I disable autorcm the boot is regular with OFW.

any suggest ?

 

[GCS]

My switch, after update to 10.2 (hekate 5.3.3 + Atmosphere) show a black screen and not boot to hetake Home (i'm using autorcm). BUT IF a put usb-C using and TEGRA on PC, hekate logo appear after 2 seconds and go to home 5.3.3. I enable emuMMC too ....but ...nothing. Before update 10.2 boot without problems. IF I disable autorcm the boot is regular with OFW.

any suggest ?

Try updating Atmosphere to the latest version if you haven't already also, try deleting and re-downloading the bootloader folder from here.

 

[luxe001]

Nothing....i try that !

I have :
Hekate 5.3.3
Atmosphere 0.14.4

 

[GCS]

Nothing....i try that !

I have :
Hekate 5.3.3
Atmosphere 0.14.4

Did you try replacing the bootloader folder too? And does this happen only on EmuNAND cfw, can you boot into SysNAND with cfw?

 

[jajamundo]

Delete all CFW stuff from your SD Card (Hetake and atmosphere folders). Download and install everything clean. If you had a theme installed make sure to delete that folder too.

Did you update using a offline method? If yes, did make sure the update matches with your SD format (Fat32 or Exfat)

 

[luxe001]

The update was downloaded before doing each mod (1 month ago) never installed. Yesterday (offline) i installed cfw with fw 10.1 and update to fw 10.2. At this point i update CFW too at last release....with black screen problem

I try to do so (tell me if is true pls):
Format SD CARD Exfat
build sd with all folders (atmosphere 0.14 etc...)
Inject Hetake 5.3.3
build emuMMC partition and activate


a quesiton: i must inject payload (in rcm mode) every time when i shutdown consolle or injecting emummc the cfw boot is auto without rmc mode.?

 

[Draxzelex]

The update was downloaded before doing each mod (1 month ago) never installed. Yesterday (offline) i installed cfw with fw 10.1 and update to fw 10.2. At this point i update CFW too at last release....with black screen problem

I try to do so (tell me if is true pls):
Format SD CARD Exfat
build sd with all folders (atmosphere 0.14 etc...)
Inject Hetake 5.3.3
build emuMMC partition and activate


a quesiton: i must inject payload (in rcm mode) every time when i shutdown consolle or injecting emummc the cfw boot is auto without rmc mode.?

In order to boot CFW, you have to perform the exploit when the console turns off meaning you have to inject the payload.