Hacking Luma questions

[ValconExe]

I just have 2 questions:

1: I have used rxTools before. Is updating Luma the same as updating rxTools?

2: I did my first time settings for Luma. Now, I want to change one of them (I want to make it so I don't have to hold L to open emuNAND). I looked it up in the wiki, that you should just hold select when it is booting, but when I did that, it just made it boot to sysNAND (even though I was holding L). Is there any way to change it other than holding select while booting?

 

[Quantumcat]

If you want to make it so it boots into emuNAND without you holding any button, then reconfigure menuhax so it boots with no buttons.
To do this, boot into the homebrew menu (you may have to temporarily replace your boot.3dsx with the original one from the starter pack) and go to menuhax installer, then pick the configure option.

 

[xyxa]

1: You can use lumaupdater to update Luma3DS.
That's for A9LH, sorry.

 

[ValconExe]

Wait, so how do I update it? (Meaning like from 11.0 to 11.1) Is it just like rxTools where you just go and choose system update in settings?

 

[Quantumcat]

Wait, so how do I update it? (Meaning like from 11.0 to 11.1) Is it just like rxTools where you just go and choose system update in settings?

Updating your firmware is the same regardless of CFW type