Hwfly oled

[Acide0]

Hi, I’m doing an hwfly install on a oled, the modchip it’s the v4 flash with the last hwfly bootloader and firmware. It’s not my first install, but the one give me headheck, I have a steady white led directly when I plug back the battery. I have redoo my caps solders and check it with multimeter and all 4 point beep on ground like usally. I have try another modchip same result. Have you any idea of what could do that ?

even with the white led if a press power the switch boot in ofw

 

[thesjaakspoiler]

On Reddit they mention that it is usually to a bad solder connection :

 

[Acide0]

I got not the same as this one, on my side I just plug in the battery and it’s giving me the white led no blinking at all and I don’t press power at all because when I press power it’s booting up the ofw.

 

[Acide0]

I will answer by myself because I found the solution by myself… it’s not a soldering issue at all….
the problem come from vcc, the original point for vcc give me 3.85v not 3.3v.
I used a no standby 3.3v that a friend give me that give a real 3.3v and now everything works perfectly !

 

[juanvlc]

I will answer by myself because I found the solution by myself… it’s not a soldering issue at all….
the problem come from vcc, the original point for vcc give me 3.85v not 3.3v.
I used a no standby 3.3v that a friend give me that give a real 3.3v and now everything works perfectly !

Can you kindly please point me where this "no stby 3.3v" is placed on?
Thanks a lot