Hey guys,
Starting info:
OLED console running 14.1.1
V4.0 HWFLY install with upgraded gold dat0 chip. Flex cable not used but all soldering points have wires instead. All values are good compared with ones on YouTube.
Training: initially pulsed yellow indefinitely. Flashed it with nx 0.7.2, took a couple tries but the flash went through in the end. It fully trained (purple then green), and I got the NOSO logo. However, after booting again, now it goes purple, then orange, then red, then turns off and boots OFW. I reflashed 0.7.2 but just repeats the cycle of purple, orange, red. I reflashed a lower firmware, same result. I tried with SD card in and SD card out, no avail.
Any suggestions?
EDIT: The only file on my sd card is payload.bin (hekate renamed)
Starting info:
OLED console running 14.1.1
V4.0 HWFLY install with upgraded gold dat0 chip. Flex cable not used but all soldering points have wires instead. All values are good compared with ones on YouTube.
Training: initially pulsed yellow indefinitely. Flashed it with nx 0.7.2, took a couple tries but the flash went through in the end. It fully trained (purple then green), and I got the NOSO logo. However, after booting again, now it goes purple, then orange, then red, then turns off and boots OFW. I reflashed 0.7.2 but just repeats the cycle of purple, orange, red. I reflashed a lower firmware, same result. I tried with SD card in and SD card out, no avail.
Any suggestions?
EDIT: The only file on my sd card is payload.bin (hekate renamed)
Last edited by tvchip,