Hello. I am unable to load into EmuNAND9 from bootctr9 using either the .bin or the .3dsx. All goes well until it jumps to payload then freezes. Any suggestions would be greatly appreciated.
I think you're autobooting into emunand? I did too, and that was the reason it didn't work with me either.
--------------------- MERGED ---------------------------
If you want to autoboot into sysnand, just create a text file called "updatedsysnand" in the rei folder and remove the .txt extension.
You can try to use Decrypt9 instead, someone made one that is compatible with A9LH
no. Decrypt9 wont allow you to format sd and create a new emunand
Ah my fault, didn't know that.
--------------------- MERGED ---------------------------
Can you share it?
Similar threads
-
BakerMan
The snack that smiles back, Ballsack! -
AncientBoi
-
Sicklyboy
-
Sonic Angel Knight
-
Xdqwerty
what are you looking at?
-
@
Psionic Roshambo:
Like not emulating the entire SNES but just a loader and the enhancement chips perhaps even slightly overclocked like FX-2 -
-
-
-
-
-
-
@
SylverReZ:
@Psionic Roshambo, The Doom NES cartridges, a few batches were made. One was given to AVGN as seen in his Doom video.+1 -
-
@
Sicklyboy:
I finally modeled and 3d printed the new HDD cages I need in order to build my 2nd NAS. Original ones don't fit the mounting holes on the hdds I'm using. Been sitting on this project for over 2 years smfh
-
-
@
Sicklyboy:
I'm finally gonna get this NAS racked and powered on tonight, install truenas core, and burn the disks in with badblocks
-
@
Sicklyboy:
Also another 70TB going in the front mount drive bays of this server. 182tb raw, going to probably use a zfs RAID-Z3 for 3 parity disks, so 140TB usable
-
@
Sicklyboy:
I could claw back 14tb by only doing 2 parity disks but I feel like with 13 disks in the RAID I'd be kind of pushing my luck on rebuild time if I encounter a disk failure
-
-
-
-
-
-
-
-
-
-
-
