Hacking High Success Rate When Attempting Downgrade With sysUpdater

[TuxSH]

(I'm supposed to be asleep ;p)

You shouldn't use my build of sysUpdater, it will likely brick your console if it freezes during the process (unlike julian20's build).

 

[OdeonVelos]

I'm confused as to if I have a successful downgrade on my n3ds?

says 9.2, downgrade checker says it downgraded properly, but no matter what I do, I can't seem to run gateway launcher or any other exploits through the browser (other than browserhax), it just loads like a normal web page.

Any suggestions?

Edit: Just found out the browser exploits don't work on the n3ds xD, I fail. I am used to working with older 3ds systems.

 

[qq194ken]

I really want to say thank you to you "KobraXMW".
I had try the old method for above ten times, after I follow the guide by you, I success just in the first time, many thanks.

 

[KobraXMW]

I really want to say thank you to you "KobraXMW".
I had try the old method for above ten times, after I follow the guide by you, I success just in the first time, many thanks.

Glad I could help

 

[derthomas]

Well that doesnt work for me. I tried both sysupdater linked. The first one glitched out constantly and the other one did nothing at all. Tried both with menu and browserhax, no success. o3ds on 10.3

 

[Midou23000]

can i downgrade sysnand New3DS 9.8.0-25E to 9.2.0-20E ? I have haxmenu on it

 

[KobraXMW]

can i downgrade sysnand New3DS 9.8.0-25E to 9.2.0-20E ? I have haxmenu on it

Yes. It should work since you are on a memchunkhax2 exploitable firmware.

 

[The Catboy]

I downgraded my 2DS when it was stupidly unstable and homebrew/cfw wouldn't work. Then upgraded to 10.3 and two hours later when I went on my break, was able to downgrade again and get CFW working. Again, I did this way back when it was stupidly unstable.
Since then, I have downgraded my 3DS and both my boyfriend's 3DS's without fail.

 

[zakwarrior]

hello, i have one question when using the TuxSHsysUpdater and following the steps so it will load strait unstead of the HBL,
can you just spam Y then if it fails B to return and load the updater again, so just spam Y > B until it works or or you have to power off then L + power on to load each time?
thx

 

[KobraXMW]

hello, i have one question when using the TuxSHsysUpdater and following the steps so it will load strait unstead of the HBL,
can you just spam Y then if it fails B to return and load the updater again, so just spam Y > B until it works or or you have to power off then L + power on to load each time?
thx

You will have to reboot each time it fails.