Gba sp new buttons. 1 wire 2 inputs issue

Discussion in 'Other Handhelds' started by 11asnyde, Apr 28, 2017.

  1. 11asnyde
    OP

    11asnyde Newbie

    Newcomer
    1
    Apr 28, 2017
    United States
    I have a control pad I want tu solder connections from.
    To override buttons on a gba sp motherboard.

    The problem is the control pad has 1 output wire per button.

    And the GBA board requires 2.

    Should I connect the control pad to the "receiving" points?
     
  2. Wiisel

    Wiisel GBAtemp Maniac

    Member
    3
    Dec 4, 2008
    You'll need to run a wire (2) for each input to the relevant traces on the controllers pcb unless the gba and the controller use a common ground

    [​IMG]

    [​IMG]
     
    Last edited by Wiisel, Apr 28, 2017
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice