Hello All! This is my second time trying to mod a switch (first one failed miserably)
And I feel I did a lot better this time.
I have installed all connections correctly, according to the readings. But I seem to get a CLK or RST Error. I'm not sure, hence why I am posting the vid. I am unable to tell which error this is. Below are my readings before I turn my switch on, I have double checked all connections and readings and they are secure. That is why this is stumping me. If anyone could offer guidance I would appreciate it.
As for the readings of my install, they are as follows
3v3 - 0.856
C/Dat0 - 0.705
A/CMD - 0.703
D/CLK - 0.662
B/Ground - 1.605
It flashes Blue once, then the following in the vid, 3 times, then nothing. The screen stays black.
What is going on here? Do I need to recall the Emmc?
And I feel I did a lot better this time.
I have installed all connections correctly, according to the readings. But I seem to get a CLK or RST Error. I'm not sure, hence why I am posting the vid. I am unable to tell which error this is. Below are my readings before I turn my switch on, I have double checked all connections and readings and they are secure. That is why this is stumping me. If anyone could offer guidance I would appreciate it.
As for the readings of my install, they are as follows
3v3 - 0.856
C/Dat0 - 0.705
A/CMD - 0.703
D/CLK - 0.662
B/Ground - 1.605
It flashes Blue once, then the following in the vid, 3 times, then nothing. The screen stays black.
What is going on here? Do I need to recall the Emmc?
Last edited by BrokenScouter,
