Hacking Question CFW stucked at Logo

[aril143]

Recently I installed the SX CORE on my mariko Switch, I formatted the SD as fat32 using GUIFormat, I put the boot.dat in the SD and managed to run the SX OS, next I backed up the NAND and installed the EmuNAND, I select the CFW option and proceed with the license activation, When I inserted the License and tried to turn on the switch It won’t pass the Logo. Here are the things I have tried so far:

I tried turning off the switch and booting the CFW thru the SX OS directly but again it stops at the logo.

If I select the OFW the switch starts normally.

If I try to boot the CFW without the license it stops at the logo.

I have the 10.1.0 on the OFW and the SX OS 3.0.5 Beta.

I tried with the SX OS 3.0.4 and the result is the same stopping at the logo.

I tired to create the emuNAND in both ways and the results are the same.

Is the CFW stopping at logo means that I damaged the caps during installation or is there any other thing to try?

 

[Draxzelex]

Recently I installed the SX CORE on my mariko Switch, I formatted the SD as fat32 using GUIFormat, I put the boot.dat in the SD and managed to run the SX OS, next I backed up the NAND and installed the EmuNAND, I select the CFW option and proceed with the license activation, When I inserted the License and tried to turn on the switch It won’t pass the Logo. Here are the things I have tried so far:

I tried turning off the switch and booting the CFW thru the SX OS directly but again it stops at the logo.

If I select the OFW the switch starts normally.

If I try to boot the CFW without the license it stops at the logo.

I have the 10.1.0 on the OFW and the SX OS 3.0.5 Beta.

I tried with the SX OS 3.0.4 and the result is the same stopping at the logo.

I tired to create the emuNAND in both ways and the results are the same.

Is the CFW stopping at logo means that I damaged the caps during installation or is there any other thing to try?

Show pics of your installation.

 

[sudeki300]

usually means you knocked somethong off your switch chip, small PCB i think

 

[laramie]

try cleaning your nand chip, use some isopropyl alchohol 91% or more with a toothbrush so lightly clean the contacts and make sure it's dry before you put it back in.

 

[Sirthizzalot]

If you used incognito on your emunand that’s the issue. I was having the same issue.

 

[paulzheng]

Recently I installed the SX CORE on my mariko Switch, I formatted the SD as fat32 using GUIFormat, I put the boot.dat in the SD and managed to run the SX OS, next I backed up the NAND and installed the EmuNAND, I select the CFW option and proceed with the license activation, When I inserted the License and tried to turn on the switch It won’t pass the Logo. Here are the things I have tried so far:

I tried turning off the switch and booting the CFW thru the SX OS directly but again it stops at the logo.

If I select the OFW the switch starts normally.

If I try to boot the CFW without the license it stops at the logo.

I have the 10.1.0 on the OFW and the SX OS 3.0.5 Beta.

I tried with the SX OS 3.0.4 and the result is the same stopping at the logo.

I tired to create the emuNAND in both ways and the results are the same.

Is the CFW stopping at logo means that I damaged the caps during installation or is there any other thing to try?

Maybe you created a hidden partiton in SD card and without emunand in it or emunand data corrupted. it could be cause the issue as well.