Hacking Question Cannot run payloads after update to 6.0.2 with ChoidujourNX

[Nicro]

Hello everyone,

even though Auto-RCM still reacts as expected, the screen stays black after a supposedly successful payload injection.
Here is the story so far:

• I started with a hackable 3.0.1 stock, no exfat switch and a 128GB(119GB) sd-card. I first got myself a "pending update" for 6.0.2 and saved that for later. With the card still formatted as exfat, I copied Kosmos V11.7.1 onto it and booted into RCM with a jig. Loading Hekate V4.6 left me with a black screen even after using different injectors and devices while recopying the card setup.

• Following the helpful advice from the Discord, I overcame my stupidity and tried the same setup on fat32, which got me into Hekate instantly. I went on to backup all the stuff.

• With ChoidujourNX V1.0.1 and the update-folder copied I successfully got ready to update to 6.0.2 with all the checks passed. (selecting exfat assuming that it could not hurt to have it...) As expected, this got me Auto-RCM and the "nogc"-profile.

• after the reboot I Loaded Hekate using the fusee-launcher on my Linux-PC as before, I got a successful launch message from the launcher but no reaction from the switch. Going through both exfat and fat32 with different setups and Hekate-profiles did not change that. On a whim, I tried the "fusee test"-payload with the same nonexistent response.

Given that this happened before, and RCM itself is still responsive, I still have hope in not owning a colorful plastic brick. I feel like I am missing out on a facepalm-worthy detail but I cannot find what said detail actually is. Can I somehow get debug-output on the payload-launch? Thank you for reading this and thanks in advance for any advice you guys can give on this.

 

[Kubas_inko]

All I can think of:
1. Reboot and try again (hold power button for 12+sec to force shut down).
2. Try/ Try another usb 3.03
3. Try different payload.

 

[mdmachine]

Try sending the payload from another device if possible as well.

 

[Fracta7]

Not possible to mess up rcm with Choi.
You should turn switch off and try again .

 

[Jonosborne87]

Use fusee primary. Hekate tends to break on updates until you update your bin file.

 

[Hayato213]

Use fusee primary. Hekate tends to break on updates until you update your bin file.

Don't bump old thread, there haven't been any post for like 4 months.