Hacking Black Screen after Atmosphere Logo

[MrEl]

My switch has been working fine (0.11.1) and as I updated Atmosphere to the latest version (0.12), Switch doesn't boot anymore.

SW firmware is 10.0.0

After the Atmosphere logo, it just goes black screen (no Nintendo logo!).

I've used the latest fusee-primary, and it looks as the problem remains the same with the older versions of the Atmosphere as well.

I can still turn off and make Switch go to RCM by pressing the power button for 20-30 secs and try again.... any suggestion for tackling this issue?


--------------------------------------------------------------
Solved
--------------------------------------------------------------

It looks as somehow my SD card was corrupted.
It works fine with the clean installed Atmosphere on the new SD card.

 

[Draxzelex]

My switch has been working fine (0.11.1) and as I updated Atmosphere to the latest version (0.12), Switch doesn't boot anymore.

SW firmware is 10.0.0

After the Atmosphere logo, it just goes black screen (no Nintendo logo!).

I've used the latest fusee-primary, and it looks as the problem remains the same with the older versions of the Atmosphere as well.

I can still turn off and make Switch go to RCM by pressing the power button for 20-30 secs and try again.... any suggestion for tackling this issue?


--------------------------------------------------------------
Solved
--------------------------------------------------------------

It looks as somehow my SD card was corrupted.
It works fine with the clean installed Atmosphere on the new SD card.

If you were using exFAT, it was the culprit of your corruption.