I just did an RGH3 on a Trinity board using my ‘quick and dirty’ method- which involves booting with a BadAvatar and dumping the Nand and cpu key, modding the nand with JRunner, then flashing the nand using the software nand flasher, which produced the red dot, as expected.- then doing the soldering afterwards.
It’s quicker than the traditional method, and usually works fine.
This time however, I got a bad block on read (and write) at 0x30, (and got the jrunner boot up warning message), but persevered anyway - and fortunately the console boots up as normal.
As everything boots up ok, can I assume all is ok, or am I likely to encounter stability problems ?
TIA
It’s quicker than the traditional method, and usually works fine.
This time however, I got a bad block on read (and write) at 0x30, (and got the jrunner boot up warning message), but persevered anyway - and fortunately the console boots up as normal.
As everything boots up ok, can I assume all is ok, or am I likely to encounter stability problems ?
TIA
