Hardware Are there any alternatives to Oled D points?

[DawnWorkout]

Hello
The OLED has become a brick I thought D point was the problem. so
I put a lot of scratches on the Oled D point
When I connect the solder wire, it keeps getting solder short...
Is there a temporary prescription to solve this problem?

I have a similar problem and the LITE device is brick because of the chip but I replace the firmware and it works without any problems.
So I'm sure that the Oled model will work normally if the updated hwfly is installed again
But the D-point is the problem...
Please let me know if there are many alternatives
Thank you for reading it.




It's out of focus I'm sorry

 

[jkyoho]

No, it goes straight from that via into eMMC on back side. If you short it or you leave it broken as is, you wont have your device boot up.