Another problem with Monster hunter tri

Discussion in 'Wii - Backup Loaders' started by Fra2oox, May 8, 2010.

May 8, 2010
  1. Fra2oox
    OP

    Newcomer Fra2oox Newbie

    Joined:
    May 29, 2007
    Messages:
    4
    Country:
    Italy
    Hi everyone! I'm trying to play MH3 with my wii:
    I've the 4.1E firmware by waninkoko, the 5th cIOS by Hermes and cIOSx 19 by waninkoko. i launch MH3 with uLoader by hermes from hard disk
    with cIOS 222, 223, 224, 249 i can start the game, but only with cIOS 223 i can pass trough the staring menù, 'cause with others my console freeze and I hear a noise.
    but with cIOS 223 i've this problem: i can play for 5, 10 minutes. after that my console wont accept anymore my commands and i don't know why °°

    if it's necessary I can post the list of every IOS that i've on my wii
     
  2. cobleman

    Member cobleman GBAtemp Maniac

    Joined:
    Jun 23, 2009
    Messages:
    1,449
    Location:
    Australia
    Country:
    Australia
    Reinstall Hermes v4 222 37/38 merge and 223 38/60 merge
    Use UsbloaderGx Rev921 set the game to boot from 222 let us know if that works for you?
     
  3. Fra2oox
    OP

    Newcomer Fra2oox Newbie

    Joined:
    May 29, 2007
    Messages:
    4
    Country:
    Italy
    I've just tried, but i had a freeze while i was going from a zone to another. I don't think that i'm using a bad dump, cause I've already visisted both zone.
     
  4. cobleman

    Member cobleman GBAtemp Maniac

    Joined:
    Jun 23, 2009
    Messages:
    1,449
    Location:
    Australia
    Country:
    Australia
    Are all your ios's upto date use DOP-Mii_v12 to check and update.
    Did you install Hermes v4 222 37/38 merge and 223 38/60 merge?
     
  5. Fra2oox
    OP

    Newcomer Fra2oox Newbie

    Joined:
    May 29, 2007
    Messages:
    4
    Country:
    Italy
    I've update my system and almost every IOS and now it seems to work, thanks!
     

Share This Page