Hardware ALT_CLK point N3DS XL?

[dg_dex]

I'm sure this question has been asked multiple times before. I've looked over the forum for an alternative clk point for n3ds xl. I've found several posts for the O3DS regarding this topic. However, I'm unable to locate a thread with the alt_clk point for n3ds xl if there ever has been one. Could you guys point me towards the correct pad to solder to if there is an alternative one? My soldering skills are good, but my tip isn't fine enough for the standard clk pad.

 

[Xenon Hacks]

I'm sure this question has been asked multiple times before. I've looked over the forum for an alternative clk point for n3ds xl. I've found several posts for the O3DS regarding this topic. However, I'm unable to locate a thread with the alt_clk point for n3ds xl if there ever has been one. Could you guys point me towards the correct pad to solder to if there is an alternative one? My soldering skills are good, but my tip isn't fine enough for the standard clk pad.

You could always heat up the tip of a steal knife and make that one contact very gently

 

[dg_dex]

You could always heat up the tip of a steal knife and make that one contact very gently

Haha I like that response. Sense humour suits you well matey.

 

[dg_dex]

Well I managed to get the error blue screen for around 10 seconds. Both screens off and on like a yo-yo now. It's thise black clips on the mobo. They aren't seating flat agaisnt the board. Any suggestions?

 

[dg_dex]

Ok, bit stuck guys. Got the blue screen error 8064 showing. However, only the bottom screen shows and the top one is lit up black. All wires are 25cm in length. Using a Transcend recommended with n3ds xl. Anyone encountered this issue? If so, is there a repair?

 

[j3yps]

Ok, bit stuck guys. Got the blue screen error 8064 showing. However, only the bottom screen shows and the top one is lit up black. All wires are 25cm in length. Using a Transcend recommended with n3ds xl. Anyone encountered this issue? If so, is there a repair?

That's normal