My suggestion for everyone doing any mtp file transfer or install is to use DBI installer instead. It has an amazing mtp protocol feature allowing you can see all usable partions on your Switch and SD card. The best being the nand (emunand) and micro sd card install where you only need to select all the NSP/NSZ file you want to install and drag copy them to the location (either micro sd or emunand) and it will install them one by one. Fast and easy.
Last edited by kerelenko,
Just dragging a nsp file over to your sd card will install it!?My suggestion for everyone doing any mtp file transfer or install is to use DBI installer instead. It has an amazing mtp protocol feature allowing you can see all usable partions on your Switch and SD card. The best being the nand (emunand) and micro sd card install where you only need to select all the NSP/NSZ file you want to install and drag copy them to the location (either micro sd or emunand) and it will install them one by one. Fast and easy.
Last edited by sillz,
I gave DBI a try but I'm having some issues. It didn't seem to recognize when I ran dbibackend.exe, and now it doesn't even recognize that it's connected via USB cable. I would love a better solution for installing via MTP. Any idea how I can get help with this?
I don't use dbibackend.exe
Just download the nro and place it inside your SD:/switch/ folder
Open DBI and select Run MTP responder
On your PC you should be able to see a drive called Switch.
Open that drive and select Micro SD install folder
Drag your nsp/nsz files to that folder to install them
If your Switch is not detected on your PC, you may need to install the libusbk drivers.
Just download the nro and place it inside your SD:/switch/ folder
Open DBI and select Run MTP responder
On your PC you should be able to see a drive called Switch.
Open that drive and select Micro SD install folder
Drag your nsp/nsz files to that folder to install them
If your Switch is not detected on your PC, you may need to install the libusbk drivers.
Last edited by kerelenko,
Thanks for your help. I was able to get as far as dragging and dropping but I got a corrupted data error. Not sure why since it installs ok with Tinfoil.
EDIT: Turns out I had a defective SD card. Will try again with a new one.
Last edited by BryanCGP,
so in Zadig make sure that tinfoil 0 is on libusbK and tinfoil 1 is stock usb drivers, this fixes that input and output interface, i couldnt find this documented anywhere but i figured it out and now its working.
