Hi everyone, I would like to request help on my Switch. I recently installed the SXCORE with green light successful and can boot to the SX bootloader. Problem is, once I try to boot into CFW, the nintendo logo comes up, followed by black screen. After that, I tried to load OFW also via sx bootloader,same thing happens.
I've read that when using SX OS 3.0.3, the OFW needs to be at v10.0.4 for it to work, but problem is I didn't update it before doing the installation. I never went online and left it as is ( OFW v3.0.0). Since I cannot enter OFW, I don't know how to update the Switch. I'm also not sure if updating will fix this black screen issue
Here are some info of the switch and what I've tried so far:
-switched the nand back to the original setup without desoldering and boot up hoping to enter OFW. It failed
-tried exfat and fat32, both had same result. SD card is a sandisk
-battery is at 90% and up the entire time (tried to use payload under options to hekate to verify the battery level)
-emunand and nand both backed up, emunand enabled failed.
-current OFW at 3.0.0, v1 erista
-read a suggestion to check one of the capacitors near the cpu shield, it's still in one piece
-used the SX OS V3.0.3. The SX OS 2.9.2 does not boot up to sx bootloader, as I've read others have experienced as well
Any help on (1) getting to load under CFW or (2) booting to OFW so I can update is greatly appreciated.
Thank you very much everyone!
I've read that when using SX OS 3.0.3, the OFW needs to be at v10.0.4 for it to work, but problem is I didn't update it before doing the installation. I never went online and left it as is ( OFW v3.0.0). Since I cannot enter OFW, I don't know how to update the Switch. I'm also not sure if updating will fix this black screen issue
Here are some info of the switch and what I've tried so far:
-switched the nand back to the original setup without desoldering and boot up hoping to enter OFW. It failed
-tried exfat and fat32, both had same result. SD card is a sandisk
-battery is at 90% and up the entire time (tried to use payload under options to hekate to verify the battery level)
-emunand and nand both backed up, emunand enabled failed.
-current OFW at 3.0.0, v1 erista
-read a suggestion to check one of the capacitors near the cpu shield, it's still in one piece
-used the SX OS V3.0.3. The SX OS 2.9.2 does not boot up to sx bootloader, as I've read others have experienced as well
Any help on (1) getting to load under CFW or (2) booting to OFW so I can update is greatly appreciated.
Thank you very much everyone!
Last edited by andy92,