[GIVEAWAY] OLED charge only one side - Correct measurements ?

  • Thread starter Thread starter linkref
  • Start date Start date
  • Views Views 488
  • Replies Replies 5

linkref

Well-Known Member
Member
Joined
Apr 14, 2019
Messages
195
Reaction score
19
Trophies
0
Age
46
XP
799
Country
France
Hi,

I will do a giveaway to the one who help me diagnose this console please guys.
I replaced the port several times put the Switch only charge on one-side and it's undetected in the dock.

At this point I do not know if I soldered bad the new usb-c port, or something else, cuz i changed it several times.
I bought a breakout board, here are my values :

first_side.pngback_sides.png

Thanks guys !

---

Edit:

I found that my 5fth pin (B5) doest not have value, can someone help me locate where does it goes so I can track id and find C/C

1779099607003.png

Even with the diagram i did not find it
 
Last edited by linkref,
The pink line is how the 5V lines are connected.
It is almost impossible not to get +5V and GND so my best guess is microcracks somewhere in the middle.
Unless you maybe have some micro crack in the middle.
When the connector takes a beating when the cable is inserted, the PCB can get bent so much that the traces crack.
I assume you would have noticed any ripped off pads when replacing the connector.

Since the Switch is always inserted into the dock with the same side forward, maybe also the USB lines are cracked.
I don't know if the Switch Dock has redundancy on the data or power lines.

1779099916385.png
 
Not sure if replacing the M92T36 would matter because then it would not charge at all.
Remove the USB-C connector and show us some pictures.
 

Site & Scene News

Popular threads in this forum