Hi Everyone,
I decided to install a custom firmware on my low serial switch (Not my first switch to use CFW on),
When I plug the jig and plug the USB-C on my PC,
PC doesnt detect a driver and no sound come out of the PC (Though the switch will be charging if the RCM is not enabled),
I have changned the PC and the Cable, the same issue appeared I even removed the APX driver and installed it again and it didnt work,
However the same set up on my second switch works just fine, is this a common and is there is a fix for it?
I decided to install a custom firmware on my low serial switch (Not my first switch to use CFW on),
When I plug the jig and plug the USB-C on my PC,
PC doesnt detect a driver and no sound come out of the PC (Though the switch will be charging if the RCM is not enabled),
I have changned the PC and the Cable, the same issue appeared I even removed the APX driver and installed it again and it didnt work,
However the same set up on my second switch works just fine, is this a common and is there is a fix for it?