Thanks. I have the required files for 3.0.1/.2 but I have problems with IDA pro, where it crashes on me after the an update.Is there anything we can do to support you with the 3.0.1 support? I have a console with this firmware and everything is prepared ...
Be patient when you launch the dump...Using version 1.6.
Started a dump on fat32 but it failed on a (16 gB) card.
Then i formatted the card on exFat on a pc.
Then formatted a second time on the switch.
Now if i start the dump, it stucks on 0%.
No error on both times? Can't help without the yellow one.Using version 1.6.
Started a dump on fat32 but it failed on a (16 gB) card.
Then i formatted the card on exFat on a pc.
Then formatted a second time on the switch.
Now if i start the dump, it stucks on 0%.
the first one was an writing error. and with the 0% stuck, nothing happens.(same error with version 1.5)No error on both times? Can't help without the yellow one.
Thanks. I have the required files for 3.0.1/.2 but I have problems with IDA pro, where it crashes on me after the an update.
I don't have time to reinstall it and migrate all my settings, workspaces, plugins, etc for now.
Are you saying the files are ready ,you just can't compile? Bummer.
You misunderstood.Are you saying the files are ready ,you just can't compile? Bummer.
That's absolutely correct.No, I get the feeling that CTCaer has the required files dumped from the 3.0.1 and 3.0.2 firmwares, but he still needs to load them into IDA pro so he can run a debug trace and figure out the correct offsets to add to the secmon_patch. Unfortunately, his installation of IDA Pro is no longer functional, so he can't do this for us.
If by chance CTCaer is willing to teach us how to fish, we can install IDA Pro and do it ourselves, but that would probably be a lot to ask.
Format it with FAT32 or exFAT in windows. Make sure the cluster size is 32KB....
That's absolutely correct.
Maybe, I'll do a new installation in a VM. But still, I don't want to find the correct variables all over again..
Slow mode writes zeroes all over the created partition.Thanks, now it works perfectly. I formatted in slow mode with exFat and 32kB.
I don't know why it stucked on 0%. Maybe the cluster size was different as i formatted the sd with the switch.
You need the secure engine binary from package1.By any chance is there a writeup on how to find these variables and offsets? It's been ages since I worked in IDA Pro but I'm a little curious how this stuff works, if you're willing to push me in the right direction. I have dump files from my 4.1.0 switch and my 3.0.2 switch. If I had the instructions available, I could try them out with my 4.1.0 dump files and see if I arrive at the same offsets that have already been committed to the source code. If I'm successful there, I assume I could then do the same with my 3.0.2 files.
Thanks. I have the required files for 3.0.1/.2 but I have problems with IDA pro, where it crashes on me after the an update.
I don't have time to reinstall it and migrate all my settings, workspaces, plugins, etc for now.