Fusee.bin black screen Atmosphère 1.11.2 and firmware 22.5.0

[SonGoku10]

Hey guys, so I just updated my Switch OLED to the latest Atmosphere version and system firmware. But whenever I try to boot the fusee.bin payload to run a save extractor on the stock side of my Switch, it just goes to a black screen. By the way, I did update fusee to the latest version and put it in the payloads folder. Any help would be awesome, thanks in advance!"

 

[thesjaakspoiler]

Can you boot into the OFW or did you maybe only update the emummc to the latest firmware?

 

[SonGoku10]

Can you boot into the OFW or did you maybe only update the emummc to the latest firmware?

I updated the OFW and the CFW partition, and I can access both without any issues; however, when I try to launch `fusee.bin` from the payloads tab in Hekate, the Atmosphere logo appears, but then the screen goes black.

 

[thesjaakspoiler]

Did you also update the fusee.bin on your SD card?
If you manually update your files, then you need to manually copy fusee.bin into the payloads folder.
Note that it needs to be the same version as the atmosphere installation on your SD card.
A version mismatch can be the cause for your black screen.

 

[SonGoku10]

Did you also update the fusee.bin on your SD card?
If you manually update your files, then you need to manually copy fusee.bin into the payloads folder.
Note that it needs to be the same version as the atmosphere installation on your SD card.
A version mismatch can be the cause for your black screen.

Yes, I downloaded the fusee.bin matching the latest version of Atmosphere; it might be an Atmosphere folder that's causing conflicts.