i dont know if this was asked here before but i ask it again.
if your here with the same problem then lets help each other out.
Hi everyone,
I’m troubleshooting a later revision Xbox Series X|S controller (Model 1914, PCB marked M1107087-010) that won't power on. Because this -010 revision differs from the early 2020 AcidMods schematics (for example, U5 on my board is an 8-pin IC with C6, C19, and C16 above it, rather than the 5-pin SOT-23 TPS613221), I don't have the exact boardview/test point layout for this revision.
What I’ve found so far:
Removed a shorted 0201 decoupling cap (C33) and installed a new TLV70733DQNR LDO on U9.
U9 has 3.3V at the input, and I also measure 3.3V around U5, so the main 3.3V line seems to be present.
However, the Enable (EN) pin on U9 stays stuck around 0.5V, so U9 isn't turning on.
Where I’m stuck:
I suspect U5 (or one of the surrounding capacitors/components) might still be faulty or pulling something down, and I want to properly test the components around U5. Since the two boards have to be connected via the 20-pin board-to-board connector to take live voltage measurements—which blocks access to the inner side—and I don't know which test points correspond to which lines on this -010 revision, I’m not sure where to start probing next.
Does anyone have pinout/test point info for the M1107087-010 revision (specifically around the 8-pin U5 and what drives U9's EN pin), or tips on the best places to probe from the accessible side while the boards are mated?
Thanks in advance!
if your here with the same problem then lets help each other out.
Hi everyone,
I’m troubleshooting a later revision Xbox Series X|S controller (Model 1914, PCB marked M1107087-010) that won't power on. Because this -010 revision differs from the early 2020 AcidMods schematics (for example, U5 on my board is an 8-pin IC with C6, C19, and C16 above it, rather than the 5-pin SOT-23 TPS613221), I don't have the exact boardview/test point layout for this revision.
What I’ve found so far:
Removed a shorted 0201 decoupling cap (C33) and installed a new TLV70733DQNR LDO on U9.
U9 has 3.3V at the input, and I also measure 3.3V around U5, so the main 3.3V line seems to be present.
However, the Enable (EN) pin on U9 stays stuck around 0.5V, so U9 isn't turning on.
Where I’m stuck:
I suspect U5 (or one of the surrounding capacitors/components) might still be faulty or pulling something down, and I want to properly test the components around U5. Since the two boards have to be connected via the 20-pin board-to-board connector to take live voltage measurements—which blocks access to the inner side—and I don't know which test points correspond to which lines on this -010 revision, I’m not sure where to start probing next.
Does anyone have pinout/test point info for the M1107087-010 revision (specifically around the 8-pin U5 and what drives U9's EN pin), or tips on the best places to probe from the accessible side while the boards are mated?
Thanks in advance!






