V2 Switch. Black screen after Launching from Hekate.

[Modzvilleusa]

Greetings,
I'm trying to troubleshoot a botched v2 install at the moment. There was no noticeable damage.
Installed a core flashed with hwfly-nx 0.7.2. emmc is samsung.
Trained and booted to hekateipl screen no problem. Pressed vol+ and vol-
Black screen.
Launching cfw sys or stock from hekate results in the same thing, no errors just launches to a black screen.
Dumped emmc, keys, boot0 boot1 no errors.
I attempted a system restore using this method

No change.
I have a replacement emmc ordered. I figure it has to be some sort of emmc issue since hekate works totally fine.
No issues detecting or benchmarking emmc in hekate
Has anyone ever seen anything like this?
Any insight would be appreciated, I'm stumped on this one.

 

[JenAtkinson]

Based on the information provided, it's possible that the issue could be related to the installation of the v2 or a problem with the emmc. It's good to hear that hekate works fine and the emmc is detected without any issues, but it's worth checking if the emmc is fully functional.

One possibility could be that the emmc is corrupted, resulting in a black screen when launching cfw sys or stock from hekate. If the replacement emmc arrives, it's worth trying to install it and see if it resolves the issue.

Another thing to consider is that the installation of the v2 could have caused some unforeseen issue that is not immediately apparent. Checking for any loose connections or inspecting the installation process may help identify the root cause of the issue.

Lastly, reaching out to the manufacturer or support forums could provide additional insight and help resolve the issue. They may have encountered similar issues or have more experience in troubleshooting the v2 installation process.