Hacking Trinket M0 Wiring

[switchn00b]

Hello, I was curious is there any way to set up a trinket m0, so the physical reset button can be removed from the trinket? (trying to make trinket as small as possible)
Wiring is the set up according to Matty's instructions.
Thanks

 

[ELY_M]

I do not recommend removing reset button at all !!!

 

[bevis]

I remove my rest buttons along with the USB port after flashing the software onto the chip. I also install a volume up strap so I can boot the chip into uf2 mode without a rest button if I need to. Only had a problem with one chip that needed to be reset so I jumped RST to GND with a jumper wire twice.

You could also try this UF2 software that never needs updating if you want https://gbatemp.net/threads/trinket...software-new-fusee_suite-uf2-packages.553998/