Homebrew Switch OLED pink screen (failed kamikaze)

[linkref]

Hi,

I kind of failed my kamikaze, still have readings on the red point, but now switch boot pink screen.
I've replaced the CMD resistor, but still pink screen, , (cmd has 4,6K reading)

What can I do ?

Thanks

 

[Hayato213]

Depending if you damaged dat0 point on the third layer if you did it is game over for that board.

 

[superfiege]

Nah, if you damaged dat0 connection you can bridge it to the other side od the pcb. Just kamikaze on the other side and then bridge it.
But I think its not a problem with dat0, otherwise the switch wouldnt even start.

 

[Gbasam64]

you severed the connection to the resistor by grinding too far "down".

 

[Nephiel]

Exactly. Try bridging the severed trace.

 

[linkref]

Exactly. Try bridging the severed trace.

Thanks a lot dude, this fixed my issue !!!! Thanks buddy