Context: Switch was sitting nice and vibing on sleep mode, and when I turned it on, it showed a hard crash, of which I forgot to write down, and needed to restart. Obviously since I'm here it didn't, and my modchip flashes purple then flashes red.
I have seen the DAT0 maybe coming loose stuff, and I will give it to the guy that did the installation, but the reason I am making this post is because the red light doesn't stay on. It blinks about 5 times then turns off. Switch DOESN'T turn off automatically after that, I have to hold it for the 12 seconds.
I will be updating the firmware on the modchip this weekend, cause apparently it has a *very* old firmware (I don't get any different results when trying to boot without the SD).
Could something else be the issue or is it just some cable that came loose and needs reseating?
Edit: After reseting the chip, it now flashes green 3 times, then red once and it repeats indefinitely.
I have seen the DAT0 maybe coming loose stuff, and I will give it to the guy that did the installation, but the reason I am making this post is because the red light doesn't stay on. It blinks about 5 times then turns off. Switch DOESN'T turn off automatically after that, I have to hold it for the 12 seconds.
I will be updating the firmware on the modchip this weekend, cause apparently it has a *very* old firmware (I don't get any different results when trying to boot without the SD).
Could something else be the issue or is it just some cable that came loose and needs reseating?
Edit: After reseting the chip, it now flashes green 3 times, then red once and it repeats indefinitely.
Last edited by SMRTG,