Switch not turning on, light on hwfly, shorted caps

[Crihaxx]

Hi there,
My switch oled isn’t booting up, hwfly with purple light then red and so on.
Sometimes when leaving in this condition boots into hekate, but very rare to happen.
Measured diodes on hwfly and values are in range, also for sp1 and sp2 resistances.
Found that there are some shorted caps in these areas.
I read a problem could be max77812 but i’m not so sure about this.

 

[meha]

was it working before or did you just install hwfly?
did you check emmc soldering points? try resoldering

 

[Crihaxx]

was it working before or did you just install hwfly?
did you check emmc soldering points? try resoldering

Yes, it was working after i bought it, already with hwfly on.
I noticed only that sometimes i had problems on sleep mode, console completely freezed and unresponsive joycons.
Haven’t checked the dat0 under emmc soldering point if you mean that one, this is the next step which will be done by the installer this week.