Switch Modchip software

[Biggersmoke]

Hi all,

I have recently had a hwfly v4 modchip installed in my Mariko Switch. I had it installed by a nearby IT repair shop.

I've had an SD card ready with hekate and atmosphere on it ready. After putting it in, the modchip was flashing red for a little while until turning solid red.
The switch then booted into the standard Nintendo screens.

Online research has shown me that the red solid light means that there is an 'issue with CLK, Dat0 or CMD connection or bad eMMC'.
My SD card software is as per below screenshots.

Any advice on how to make it work?

Video of the led flashing:

 

[binkinator]

Hi all,

I have recently had a hwfly v4 modchip installed in my Mariko Switch. I had it installed by a nearby IT repair shop.

I've had an SD card ready with hekate and atmosphere on it ready. After putting it in, the modchip was flashing red for a little while until turning solid red.
The switch then booted into the standard Nintendo screens.

Online research has shown me that the red solid light means that there is an 'issue with CLK, Dat0 or CMD connection or bad eMMC'.
My SD card software is as per below screenshots.

Any advice on how to make it work?

View attachment 342261 View attachment 342262
View attachment 342263
View attachment 342264


Video of the led flashing:
View attachment 342260

Advice? Take it back to the installer and have them check their work. At best they can redo their steps and fix the install, at worst the system has been damaged and needs professional repair. There is nothing in Software that will fix this.