Ok so I've had a hacked switch for a while now. I was in sysnand with autorcm enabled. I shut off my switch the normal way by holding the power button.
And set it in the dock for the night. When I went back to it the next morning I tried to send an exploit(hekate) which is what I normally use. tegrasmasher did not recognize my switch. I tried a shorter cable. A few resets. I tried entering recovery mode. Nothing worked. Well I got to the point of giving up and decided at that point I may need to buy a new one. Well I opens it and removed the aluminum plate. Well long story short I disconnected the emm chip. Then the computer recognized it and would take exploits. It would not boot all the way into the os complaining about the chip missing, but if I went back to hekate and plug the chip back in(while running) it would post. Now if I go back to rcm it stopped booting was not recognized by windows again. Unplugged the chip and did the cycle again. And it's works.
Any ideas?
And set it in the dock for the night. When I went back to it the next morning I tried to send an exploit(hekate) which is what I normally use. tegrasmasher did not recognize my switch. I tried a shorter cable. A few resets. I tried entering recovery mode. Nothing worked. Well I got to the point of giving up and decided at that point I may need to buy a new one. Well I opens it and removed the aluminum plate. Well long story short I disconnected the emm chip. Then the computer recognized it and would take exploits. It would not boot all the way into the os complaining about the chip missing, but if I went back to hekate and plug the chip back in(while running) it would post. Now if I go back to rcm it stopped booting was not recognized by windows again. Unplugged the chip and did the cycle again. And it's works.
Any ideas?
