Plastic is loose on ez-flash IV miniSD

Discussion in 'GBA - Flashing Hardware and Software' started by blucah, Sep 1, 2010.

Sep 1, 2010
  1. blucah
    OP

    Newcomer blucah Newbie

    Joined:
    Sep 1, 2010
    Messages:
    3
    Country:
    United States
    Hello,

    I have bought 4 ez-flash IV miniSD cards, and they all came with the plastic loose on the side, as you can see on the following image:

    [​IMG]

    When pressing this loose plastic part, a click can be heared and sometimes this part gets stuck as I should be, but it easily opens again.
    Here you can see a video which shows this: http://www.youtube.com/watch?v=CMZ_wqNC0bo

    What is happening here ?
    How can I fix this ? With glue ? Or opening and closing the card can fix the problem ?

    This has never happened before with earlier cards.

    Thank you.
     
  2. Cuelhu

    Member Cuelhu КУ!

    Joined:
    May 19, 2010
    Messages:
    536
    Location:
    Fantasy Land
    Country:
    recently I've bought one and it doesn't open like this, but there's a little opening in the corner next to the miniSD slot. It's safe inside my SP so I don't care, at last it's a pretty solid cart... [​IMG]

    If you're going to glue, be careful with the contacts and everything else inside the cart.
     
  3. how_do_i_do_that

    Member how_do_i_do_that Blue Wizard is about to die.

    Joined:
    May 16, 2008
    Messages:
    4,808
    Country:
    Antarctica
    You can close it back up with a small drop of super glue.
     

Share This Page