Hey guys,
Bit of an amatuer installer probably done 15 or so without issue.
But this one is driving me mental, no matter what I try I can't get OFW to boot. Can create an emuMMC and boot CFW with not issues.
Restart to OFW or power + volume -/+ gives me a Nintendo logo and then nothing but a black screen.
The switch was brand new hadn't setup OFW prior to modding.
Thought it was a DAT0 problem but the alignment and diode measure seems fine (~.760 black probe on ground diode mode) the other values are within spec, someone remind me what they should be just in case.
If I remove the ribbon cable connectors from the chip OFW boots fine so it doesn't appear that anything on the board is damaged. Also tried another chip with the same results.
Could it be a chip firmware problem? I'm not sure what else to troubleshoots from here.
Any help would be appreciated.
Bit of an amatuer installer probably done 15 or so without issue.
But this one is driving me mental, no matter what I try I can't get OFW to boot. Can create an emuMMC and boot CFW with not issues.
Restart to OFW or power + volume -/+ gives me a Nintendo logo and then nothing but a black screen.
The switch was brand new hadn't setup OFW prior to modding.
Thought it was a DAT0 problem but the alignment and diode measure seems fine (~.760 black probe on ground diode mode) the other values are within spec, someone remind me what they should be just in case.
If I remove the ribbon cable connectors from the chip OFW boots fine so it doesn't appear that anything on the board is damaged. Also tried another chip with the same results.
Could it be a chip firmware problem? I'm not sure what else to troubleshoots from here.
Any help would be appreciated.