o3DS (j) Hardmod Help

Discussion in '3DS - Console, Accessories and Hardware' started by WarmSmells, Mar 8, 2016.

  1. WarmSmells
    OP

    WarmSmells Newbie

    Newcomer
    6
    0
    Mar 8, 2016
    United States
    Hello, all. This is my first post here.

    I was following a guide for o3ds hardmod to dump the sysnand when I realized that some of the pins were different on my Japanese DS compared to the one shown in the wiki photos.

    This is the pins for o3ds showing CMD and DAT0-3 from the gbatemp wiki.
    Warning: Spoilers inside!


    Here is a terrible picture of my board, but it illustrates that there is one extra contact. The board under the shield to the right is also branded Samsung rather than Toshiba.
    Warning: Spoilers inside!

    Which pins should I solder to? Are CMD and DAT0 in the same place? I'd rather not assume, and I'm sure someone can relate.

    Any words of wisdom for someone performing this project?
     
  2. j3yps

    j3yps GBAtemp Regular

    Member
    117
    16
    Dec 3, 2015
    Manila, Ph
    Here you go


    [​IMG]
     
    WarmSmells likes this.
  3. WarmSmells
    OP

    WarmSmells Newbie

    Newcomer
    6
    0
    Mar 8, 2016
    United States
    Thanks m8, I'll try this out tonight then.
     
  4. j3yps

    j3yps GBAtemp Regular

    Member
    117
    16
    Dec 3, 2015
    Manila, Ph
    Goodluck!
     
    WarmSmells likes this.
  5. WarmSmells
    OP

    WarmSmells Newbie

    Newcomer
    6
    0
    Mar 8, 2016
    United States
    Ayy thanks again, I managed to get ye olde blue screen using those pins. CLK being right there was hella nice.

    Warning: Spoilers inside!
     
  6. j3yps

    j3yps GBAtemp Regular

    Member
    117
    16
    Dec 3, 2015
    Manila, Ph
    It's a huge convenience indeed! Congrats bud
     
    WarmSmells likes this.