Hardware o3DS (j) Hardmod Help

[WarmSmells]

Hello, all. This is my first post here.

I was following a guide for o3ds hardmod to dump the sysnand when I realized that some of the pins were different on my Japanese DS compared to the one shown in the wiki photos.

This is the pins for o3ds showing CMD and DAT0-3 from the gbatemp wiki.

Spoiler

Here is a terrible picture of my board, but it illustrates that there is one extra contact. The board under the shield to the right is also branded Samsung rather than Toshiba.

Spoiler

Which pins should I solder to? Are CMD and DAT0 in the same place? I'd rather not assume, and I'm sure someone can relate.

Any words of wisdom for someone performing this project?

 

[j3yps]

Here you go

 

[WarmSmells]

Thanks m8, I'll try this out tonight then.

 

[j3yps]

Thanks m8, I'll try this out tonight then.

Goodluck!

 

[WarmSmells]

Goodluck!

Ayy thanks again, I managed to get ye olde blue screen using those pins. CLK being right there was hella nice.

Spoiler

 

[j3yps]

Ayy thanks again, I managed to get ye olde blue screen using those pins. CLK being right there was hella nice.

Spoiler

It's a huge convenience indeed! Congrats bud