Hi!
I have a 3ds XL version which has (of course a) different pcb board layout and also uses slightly different components than the base version of the 3ds (http://www.3dbrew.org/w/images/a/a5/CTR_NAND_pinout.png).
Is there any information about the pinout to actually access the flash on the xl version?
Specifically, the NAND flash used is a: KLM2G1HE3F
The pcb board around this chip: http://img.gawkerassets.com/img/17uht7wozjkmmjpg/ku-medium.jpg
Interestingly, the testpoints TP249-TP253 are also in close vicinity -- including TP260 which could be a more conveniently reachable CLK signal.
Finally - if you are able to dump your nand flash at a specific firmware version, can you go back to this state at a later point in time - say after one or more upgrades?
Thanks for any input!
I have a 3ds XL version which has (of course a) different pcb board layout and also uses slightly different components than the base version of the 3ds (http://www.3dbrew.org/w/images/a/a5/CTR_NAND_pinout.png).
Is there any information about the pinout to actually access the flash on the xl version?
Specifically, the NAND flash used is a: KLM2G1HE3F
The pcb board around this chip: http://img.gawkerassets.com/img/17uht7wozjkmmjpg/ku-medium.jpg
Interestingly, the testpoints TP249-TP253 are also in close vicinity -- including TP260 which could be a more conveniently reachable CLK signal.
Finally - if you are able to dump your nand flash at a specific firmware version, can you go back to this state at a later point in time - say after one or more upgrades?
Thanks for any input!