Hacking Hardware Modded switch doesn’t boot after injecting emuMMC phase

[prob_yuko]

After a white screen from a “injecting emummc fs id..” then it doesnt boot anymore, and also it got blink 2 blue light and finally a white light. Anyone got any solution or anything? Thanks!
p.s: I was assume my sdcard nuked but turn out its not, still have all the content with it

 

[MentendoSnitch]

The blinks show that the chip Is glitching Just fine, so the problem Is very likely software, particularly of your SD card, what SD card are you using? Is It formatted in FAT32? It could even be that the EmuMMC was corrupted during the writing sequence, try to format It and install on it a vanilla atmosphere and Hekate pack and try to build again an EmuMMC from Hekate

 

[prob_yuko]

The blinks show that the chip Is glitching Just fine, so the problem Is very likely software, particularly of your SD card, what SD card are you using? Is It formatted in FAT32? It could even be that the EmuMMC was corrupted during the writing sequence, try to format It and install on it a vanilla atmosphere and Hekate pack and try to build again an EmuMMC from Hekate

Thank you for the replied, I bought a new SD card and install fresh FW and its working fine again. Maybe I was doing wrong at gathering files for the sdcard tho

 

[MentendoSnitch]

So Happy that it's working again!