Modded OLED - Creating backup, then slow memory warning and now won't boot.

[Merkel]

I modded my OLED with a picofly earlier. It booted in to Hekate and I was going through the setup process. About halfway through creating the backup I got the slow memory warning. Turned it off and now it won't boot.


I've modded a few other Switches, and I haven't seen this error before - has anyone else had this mid way through the backup process?

 

[thesjaakspoiler]

A Switch needs a working emmc to boot to Hekate, even if you use the emummc.
A slow memory warning usually is an issue with the emmc connections to the main board.

If you have a picofly on a board that you can disconnect, then try to see if you get a blue screen when you power up.

 

[Merkel]

Thanks for the response. I've got it working now, I think the wire I used for DAT0 must have shorted on something.