Hey guys! I need some help on an issue that happened recently.
I updated my switch to firmware 10.0.4 using choidujour and the latest ReiNX custom firmware 3.0. I activated the "exfat support" option in choidujour, and autoRCM is enabled. I rebooted the switch and everything looked good, I went to settings and saw version 10.0.4 with ReiNX in parenthesis.
I then added some contents to my microSD card (just some NSPs and Goldleaf), used TegraRCM to reboot my switch, and got an error message on the top left corner of my switch. It appears so fast that it's impossible to read or get a proper image of, but I did the best I could. I used a different microSD card with a clean install of ReiNX, and same results. "Setting up MOS (?), Firmware bb 30 (?)"
Removing the microSD card and using TegraRCM yields the below message. Pressing power allows me to reboot instantly, but the other buttons do nothing. If I press the volume buttons, it flashes the same error as the one above and crashes the switch.
After the switch has crashed from the error message, I have to hold the power button down for 20 seconds before I can try again. Is my switch bricked? Thanks in advance for the help!
I updated my switch to firmware 10.0.4 using choidujour and the latest ReiNX custom firmware 3.0. I activated the "exfat support" option in choidujour, and autoRCM is enabled. I rebooted the switch and everything looked good, I went to settings and saw version 10.0.4 with ReiNX in parenthesis.
I then added some contents to my microSD card (just some NSPs and Goldleaf), used TegraRCM to reboot my switch, and got an error message on the top left corner of my switch. It appears so fast that it's impossible to read or get a proper image of, but I did the best I could. I used a different microSD card with a clean install of ReiNX, and same results. "Setting up MOS (?), Firmware bb 30 (?)"
Removing the microSD card and using TegraRCM yields the below message. Pressing power allows me to reboot instantly, but the other buttons do nothing. If I press the volume buttons, it flashes the same error as the one above and crashes the switch.
After the switch has crashed from the error message, I have to hold the power button down for 20 seconds before I can try again. Is my switch bricked? Thanks in advance for the help!
