Hardware Instinct NX6

[Jamyz]

Hi.
I have a problem with the chip Instinct NX V6.
HE blink red and boot at OFW. At first thinking is the flex DAT0 fail. I do Kamikaze method with wire.
But same Problem.
What i do to check again ?
Thanks

 

[alecocr20]

Hello,

I had the exact same issue but mine was booting once in a while to heakte.
I had to replace the chip, I went with a V6 instead of the V6S and now it's working like a charm.

 

[Jamyz]

Hello,

I had the exact same issue but mine was booting once in a while to heakte.
I had to replace the chip, I went with a V6 instead of the V6S and now it's working like a charm.

Yes i see your post after create this one. But i dont have V6.. And no more on Aliexpress

Post automatically merged: May 10, 2024

Hello,

I had the exact same issue but mine was booting once in a while to heakte.
I had to replace the chip, I went with a V6 instead of the V6S and now it's working like a charm.

Do you use the black flex to connect 3.3V,D,C, A and Gain ?

 

[psycho-neon]

Did you check all points? Are they on correct reading?

 

[alecocr20]

I did use the flex cable that comes with the chip. I tried debugging the issue disconnecting each point individually and I got the correct error code.
Afterwards, I tried putty but it gave me again the correct values so it all pointed to the chip.
From what I found flashing red is an FPGA error

 

[xawak67952]

Update V6s to 1.3 or 2.0 and reset chip to the factory settings