Hello Everyone,
Long story short is I just sat down yesterday and modded my patched switch (V1?) with traditional HWFLY4 and provided V1 CPU ribbon. It worked and I could get into Hekate. Problems started when I tried to back up emuMMC via partitioning on SD card.
After that, I accidentally update to switch firmware 18.1.0. In an effort to start fresh I wiped the sd card after transferring the emuMMC folder and put the hekate payload. After no results I might have killed HWFLY USB debug due to wrong orientation.
Now when I turn the switch on it flashes purple like it's going to glitch then proceed to turn white and boots to switch original firmware. Did I brick the modchip?
I have an HWFLY RP2040 on the way just in case. Does anyone know if the CPU ribbon is interchangeable?
Long story short is I just sat down yesterday and modded my patched switch (V1?) with traditional HWFLY4 and provided V1 CPU ribbon. It worked and I could get into Hekate. Problems started when I tried to back up emuMMC via partitioning on SD card.
After that, I accidentally update to switch firmware 18.1.0. In an effort to start fresh I wiped the sd card after transferring the emuMMC folder and put the hekate payload. After no results I might have killed HWFLY USB debug due to wrong orientation.
Now when I turn the switch on it flashes purple like it's going to glitch then proceed to turn white and boots to switch original firmware. Did I brick the modchip?
I have an HWFLY RP2040 on the way just in case. Does anyone know if the CPU ribbon is interchangeable?
Attachments
Last edited by jbarrymorejr,
