Homebrew Question Homebrewing switch

[shantaelover69420]

Hey all! I'm looking to homebrew my switch with a CFW. I'm using a HAC-001 model Switch with 8.1.0 Firmware. What's the best way to go about doing this? Should I push a payload using a jig? Or is there another way? I prefer to do it myself without using modchips because I'm broke lol

 

[Hayato213]

If it is RCM exploitable them you would need a jig to enter RCM mode the first time, then you can turn on AutoRCM to get rid the need of the jig, if your payload won't go through you might have a patched unit.

 

[shantaelover69420]

I'm a bit of a noob to this stuff, is there an easy to use guide on how to do this? Or are those banned on the forum?

 

[Hayato213]

Guide is allowed on the forum not warez, first you needs to find out if you can push a payload or not, so first thing you need is a RCM jig. If you don't have one come back after you have one, you can also check your serial #, to check if it is patched or not, if it patched you can't do anything above 4.1.0 right now.

https://ismyswitchpatched.com/
https://damota.me/ssnc/checker

 

[shantaelover69420]

So I ground pins 1 and 10 with my jig. What is supposed to happen?

 

[Hayato213]

So I ground pins 1 and 10 with my jig. What is supposed to happen?

It allow you to enter RCM mode to push a payload if jig is working correctly.

https://gbatemp.net/threads/a-defin...atched-or-not-purchases-after-07-2018.512018/

Follow this to test if you got patched unit or not.

 

[shantaelover69420]

So i'm good to go?