Hello I installed SXOS on my switch to install emuNAND. So after I setup emuNAND on my switch through SXOS I installed hekate and setup an ini file to boot whatever cfw I want or stock fw. I have only atmosphere and SXOS set up through hekate including stock firmware. Now I updated my switch without burning fuses by doing the hold volume up button while updating. I have been doing this for the last couple of updates since 8.0 and had no issues. This time it worked correctly, and it booted into hekate. I updated all my files per usual once they offered 10.0.0 support. I installed autoRCM again and this time my switch won’t boot stock firmware. It goes through the hekate boot but doesn’t even get to the Nintendo switch logo anymore? I can’t get it to boot at all and it’s been almost a week now. I can’t for the life of me figure out what happened? I then decided to try emuNAND it booted fine on 9.2.0. After that I updated my emuNAND to 10.0.0 through choi and it worked. I replaced all files again and I get nosigcheck for emuNAND. I know I don’t have the latest patches as they usually come out a minute after but I’ve never had a boot issue like that. Can anyone tell me what’s going wrong? Thank you
Last edited by Powerful,