Help Needed Ripping Skyward Sword Model

Discussion in 'Wii - Hacking' started by Cameron Winget, Nov 28, 2012.

Nov 28, 2012
  1. Cameron Winget
    OP

    Newcomer Cameron Winget Newbie

    Joined:
    Nov 28, 2012
    Messages:
    2
    Location:
    Orem, Utah
    Country:
    United States
    I'm just gonna be blunt. I've looked through all the obvious files and have had no luck finding the model I need; it's at the end of Skyward Sword when Link stabs the Master Sword into the pedestal at the sealed temple. The sword model they used there was much higher poly count than the in-game model and I've been trying for hours looking for it. Long story short, I can't.

    If anyone's up for a challenge, and 50% off on a replica of said sword (normally $175) then have at it! I've pretty much given up finding it and my computer's a Mac so I can't use a 3D Printscreen or 3D Ripper DX. Believe me, I've tried.

    For a picture of a Master Sword replica I've made, here's a link.
    http://fc06.deviantart.net/fs70/i/2012/240/e/0/master_sword_2__rough_painted__by_cwinget-d5crr5h.jpg

    Except I know I can do better with a better model. Even telling me where the file would be located on the disk would be useful (but if you find it, convert it to an .obj and email it to me that'd be even better because you get half-off on a Master sword or Goddess sword replica).

    Thank you all!
     
  2. Forest_GS

    Newcomer Forest_GS Newbie

    Joined:
    Nov 29, 2012
    Messages:
    8
    Country:
    United States
    Have you tried running WindowsXP off of a bootable USB drive and running 3D ripper DX on that?
     
  3. Cameron Winget
    OP

    Newcomer Cameron Winget Newbie

    Joined:
    Nov 28, 2012
    Messages:
    2
    Location:
    Orem, Utah
    Country:
    United States
    Yeah, and unfortunately the 3D drivers are emulated so 3D ripper DX can't read them unless it's actual windows. If I made a save state right at the point when the sword is on screen do you think you could rip the files for me? Or... somebody?
     

Share This Page