So I just update the payload then update the system so when I start ironhax and it just show the load then back to home menu
What you mean reinstallAfter you updated the payload, you did reinstall ironhax to OLD / NEW 10.3 correct?
Is it the same thing as update the payloadyou have to reinstall ironhax after payload update
Maybe I did more than I had to? The more important question is what did OP do?Wait wait wait wait
1. You grab the ironhax installer from latest starter kit.
2. You get to hbl and run it.
3. You choose your Ironfall version (either 1.0 or 1.1) and the slot you want to install to.
4. You choose if your 3DS is the OLD version or the NEW one.
5. You select 10.3 as the firmware version as is the one you're updating to.
6. You choose if your 3DS is EUR or USA region.
7. It should download the proper payload and install ironhax without asking anything else.
8. Now you update your 3DS firmware to 10.3
9. IronHax should be working again.
Isn't those the correct steps? What did you do?
Wait wait wait wait
1. You grab the ironhax installer from latest starter kit.
2. You get to hbl and run it.
3. You choose your Ironfall version (either 1.0 or 1.1) and the slot you want to install to.
4. You choose if your 3DS is the OLD version or the NEW one.
5. You select 10.3 as the firmware version as is the one you're updating to.
6. You choose if your 3DS is EUR or USA region.
7. It should download the proper payload and install ironhax without asking anything else.
8. Now you update your 3DS firmware to 10.3
9. IronHax should be working again.
Isn't those the correct steps? What did you do?
I think Ocarina of Tima it's not independent and you need another entrypoint already set-up to install itOHHHH, when i was updating ironhax, i was unable to change the firm ver, so i left 10.1.... now that was my problem!
well... Time to make my Ocarina of Time a Entrypoint =(
Thx for the info
yep, i know, i will try to borrow a 3DS =P, thx again!I think Ocarina of Tima it's not independent and you need another entrypoint already set-up to install it
This is what I did ^Wait wait wait wait
1. You grab the ironhax installer from latest starter kit.
2. You get to hbl and run it.
3. You choose your Ironfall version (either 1.0 or 1.1) and the slot you want to install to.
4. You choose if your 3DS is the OLD version or the NEW one.
5. You select 10.3 as the firmware version as is the one you're updating to.
6. You choose if your 3DS is EUR or USA region.
7. It should download the proper payload and install ironhax without asking anything else.
8. Now you update your 3DS firmware to 10.3
9. IronHax should be working again.
Isn't those the correct steps? What did you do?
Oh ok I mess up I forgot to put it to 10.3Wait wait wait wait
1. You grab the ironhax installer from latest starter kit.
2. You get to hbl and run it.
3. You choose your Ironfall version (either 1.0 or 1.1) and the slot you want to install to.
4. You choose if your 3DS is the OLD version or the NEW one.
5. You select 10.3 as the firmware version as is the one you're updating to.
6. You choose if your 3DS is EUR or USA region.
7. It should download the proper payload and install ironhax without asking anything else.
8. Now you update your 3DS firmware to 10.3
9. IronHax should be working again.
Isn't those the correct steps? What did you do?