Hello and thank you, for nice guide.
In your opinion is mandatory install also DVDx to enable dvd reading (DVD video and DATA)
Ask this because i can't run any Gamecube loader using this gui, and think
it's a cios problem.
During softmod you have explained you let decide to install or not DVDx, this can influence
gamecube loader to work ?
I've request help also
there but think is important say
that gamecube loader may have problem using mios level suggested.
Thank you again for any help and reply,
m.
DVDx is not mandantory for anything unless you plan on watching dvds. GameCube games do not work with the cIOS from this guide as they are something entirely different. You need an mIOS or something for GameCube games.
Suiton said:
I followed all steps, but Neogamma r7 (non-wad) gives a cannot read error 1101. Is it a burning defect for sure, or did I do something wrong?Could possibly be a bad burn. You're using dvd-r?
Hyuukai said:
I have followed everything in the guide, do i need some special loader to load games of a hard drive? and also gamecube games do i need s special launcher? if so can you recommend some pleaseFor usb loading, you can use usb laoder gx, coverflow, configurable usb loader.. depends on your preference. For GameCube games, I'd have to search.
QUOTE(sk8mystery23 @ Sep 16 2009, 08:07 PM) thanks for the help.. when i get a chance ill update and shiz.. will this install the the loader that boots my games in the disc channel instead of having to launch something else?
Nope. That's cIOSCORP. If you don't know what you're doing, good chance you'll end up bricking-- if not by installing then definitely by uninstalling. I've never found anything wrong with a separate channel to load disks. Sure it's cool to load from the disk channel, but rewriting all of your IOSs seems like way too much work for something so trivial.
QUOTE(Infectedlie @ Sep 16 2009, 08:37 PM)
literally(less then 20 minutes ago) just bricked a friend's wii using this guide. I've done 4 Wii's before, and this is the first time I've ever actually experienced a brick. trying to back it up with the nand.bin I had created earlier gives no positive results... basically just the system menu is broken happened after I was updating his firmware to 4.0 from 3.4u.
regardless of this, thanks for the guide(which I used the other four times)