Error when booting OLED into CFW "Failed to read GPT: 0x0007018"

[Megradome]

Hey all, just installed a chip into my OLED and I am getting this error whenever I try to boot my fusee payload through hekate.

Failed to read GPT: 0x0007018

I formatted the card to Fat32 and tried another Micro-SD card that always works.

Post automatically merged: Jul 31, 2024

Hey all, just installed a chip into my OLED and I am getting this error whenever I try to boot my fusee payload through hekate.

Failed to read GPT: 0x0007018

I formatted the card to Fat32 and tried another Micro-SD card that always works.

Update: EMMC Says it is initialized in a slower state when checked in hekate, not sure why this is happening since it boots into Hekate.

 

[thesjaakspoiler]

Update: EMMC Says it is initialized in a slower state when checked in hekate, not sure why this is happening since it boots into Hekate

That means that 1 or more datalines of the emmc have a bad connection.
emmcs have some sort of backup feature where they can run with a single dataline instead of all 8.
Hekate and the rest will work but it will be 8 times as slow.

If you used a DAT0 adapter, then maybe it's causing this issue.

 

[Megradome]

That means that 1 or more datalines of the emmc have a bad connection.
emmcs have some sort of backup feature where they can run with a single dataline instead of all 8.
Hekate and the rest will work but it will be 8 times as slow.

If you used a DAT0 adapter, then maybe it's causing this issue.

You'd say switch the DAT0 piece from the modchip and try again? If I do so I'll take pics of the solder afterwards.

Post automatically merged: Jul 31, 2024

That means that 1 or more datalines of the emmc have a bad connection.
emmcs have some sort of backup feature where they can run with a single dataline instead of all 8.
Hekate and the rest will work but it will be 8 times as slow.

If you used a DAT0 adapter, then maybe it's causing this issue.

I tried replacing the DAT0 piece and no help still not working. Not sure why.