Emunand 10.7 working?

Discussion in '3DS - Flashcards & Custom Firmwares' started by Hamstermascot, Mar 28, 2016.

  1. Hamstermascot
    OP

    Hamstermascot GBAtemp Regular

    Member
    199
    46
    Mar 1, 2016
    Netherlands
    I'm not sure if I should update it yet, but can assume that I can update my emunand to 10.7 without issue's?
     
  2. CrispyYoshi

    CrispyYoshi GBAtemp Advanced Maniac

    Member
    1,516
    502
    Mar 20, 2010
    United States
    Which CFW are you running (Cakes, AuReiNAND, Rxtools...), and what entrypoint are you using? (A9LH, menuhax, etc)
     
  3. Hamstermascot
    OP

    Hamstermascot GBAtemp Regular

    Member
    199
    46
    Mar 1, 2016
    Netherlands
    I'm using rxtools using the ninjhax.
     
  4. CrispyYoshi

    CrispyYoshi GBAtemp Advanced Maniac

    Member
    1,516
    502
    Mar 20, 2010
    United States
    I think that should be fine then, although I'd advise using menuhax instead, or even A9LH if you're up for the long tutorial to achieve a ~9-second CFW boot.
     
  5. Lacius

    Lacius GBAtemp Guru

    Member
    6,118
    2,448
    May 11, 2008
    United States
    10.7 emuNAND works just fine with rxTools assuming you have the correct files on your SD card.
    As a side note, is there any reason you're still using ninjhax as your entrypoint?
     
    CrispyYoshi likes this.
  6. Hamstermascot
    OP

    Hamstermascot GBAtemp Regular

    Member
    199
    46
    Mar 1, 2016
    Netherlands
    Ahh, mostly because I switched back to cfw yesterday. Got a sky3ds plus with the cubic ninja rom and used it to launch hbl constantly to play region free. Haven't done any updating yet on the emunand, so its on 9.2 atm. I set up menuhax before I update though.