where did I go wrong?
The FBI stuff won't load up...
It all seemed to be going smoothly,up until aroundSection III - Configuring Luma3DS of here:https://3ds.guide/installing-arm9loaderhax
After finishing this section, I pressed start to have it save and reboot like it instructs you to do. It didn't reboot though. It just stayed in a grayish dark screen until I had to turn it off.
Earlier in the guide, it kind of scared me into creating a nand backup before I followed a part of the guide that stressed repeatedly the importance of nand backups. Then when I was about to do the CTR TRANSFER thing, it prompted me to do another nand backup, so I did. I'm not sure if that was my mistake. So right now I have two nandico backups on my mem card
So I went back to the step before FBI injection, which i had skipped because I thought it wasn't meant for me given how it was worded, and I did that step. So now when I insert the SD card I used to actually follow the guide with, a 32gb micRo SD in a SD adaptor, it does boot but it doesn't load the FBI in the health and safety section. When I check my firmware version, it says 11.2.0-35u... so it's the same exact firmware it had when I bought it. Also, another strange issue right now, when I insert the SD card that came with the system, it won't boot up at all.
The FBI stuff won't load up...
It all seemed to be going smoothly,up until aroundSection III - Configuring Luma3DS of here:https://3ds.guide/installing-arm9loaderhax
After finishing this section, I pressed start to have it save and reboot like it instructs you to do. It didn't reboot though. It just stayed in a grayish dark screen until I had to turn it off.
Earlier in the guide, it kind of scared me into creating a nand backup before I followed a part of the guide that stressed repeatedly the importance of nand backups. Then when I was about to do the CTR TRANSFER thing, it prompted me to do another nand backup, so I did. I'm not sure if that was my mistake. So right now I have two nandico backups on my mem card
So I went back to the step before FBI injection, which i had skipped because I thought it wasn't meant for me given how it was worded, and I did that step. So now when I insert the SD card I used to actually follow the guide with, a 32gb micRo SD in a SD adaptor, it does boot but it doesn't load the FBI in the health and safety section. When I check my firmware version, it says 11.2.0-35u... so it's the same exact firmware it had when I bought it. Also, another strange issue right now, when I insert the SD card that came with the system, it won't boot up at all.
Last edited by alexg1989,